Ethernet Help

The format of the ethernet parameter is as follows:

        ether=irq,base_addr,mem_start,mem_end

This shouldn't be necessary for many cards, however.  An example
might look like:

        boot:  linux ether=11,0x360

Note:
The last two parameters can be left out most (if not all) of the time.
Also, linux will only recognize the first ethernet card in a system.
To get it to see two, you must use something like:

        boot:  linux ether=0,0,eth1

For more information on that, see the Multiple-Ethernet mini HOWTO.



[F1-Main] [F2-CD] [F3-SCSI] [F4-Ether] [F5-Other] [F6-Help] [F7-Single]